Soft99 Perfect Foam Starter Kit

The kit includes the Soft99 Perfect Foam shampoo concentrate and a dedicated foam bottle, giving you everything you need to start a foam pre-wash without sourcing equipment separately.

The kit is designed to work with the included foam bottle, which does not require a pressure washer. If you have a pressure washer and foam lance, the shampoo is compatible with that setup too for even denser coverage.

Yes. The pH-balanced formula will not strip or degrade wax, synthetic sealants or ceramic coatings. It is safe to use as a regular maintenance wash on protected vehicles.

A dwell time of two to five minutes is typical. Allow the foam to work on the surface and lift contamination, but rinse before it dries completely, especially in direct sun or warm conditions.

On lightly soiled vehicles, a foam pre-wash followed by a thorough rinse can handle most surface dust and grime without mitt contact. For heavier dirt, road tar or mud, follow up with a wash mitt and a fresh bucket of shampoo solution after rinsing the foam off.

The formula is gentle enough for use on painted wheels, glass and rubber or plastic trim. It will not stain or dry out rubber seals, and it rinses cleanly from glass without leaving streaks.

Follow the ratio indicated on the product label, typically a small amount of concentrate topped up with water in the foam bottle. A higher concentrate ratio produces denser foam, while a leaner mix is fine for lighter soiling and maintenance washes.

Yes. Once the vehicle is rinsed, dried and the paint is clean and decontaminated as needed, you can apply any wax, sealant or ceramic topper on top. The foam wash leaves no residue that would interfere with bonding.