Guaranteed safe checkout
Total price R 845.00
Clean Debadging
The Soft99 Emblem Remover Kit pairs a controlled cutting line with a clear-coat safe adhesive remover so you can pull factory badges, OEM emblems and dealership stickers cleanly - no scratching, no residue left behind, no shortcuts missing from the kit.
Why Soft99 Emblem Remover
Purpose-built tools for a clean, controlled removal from start to finish.
Purpose-formulated remover dissolves adhesive without attacking the paint underneath.
Factory adhesive tape breaks down at ambient temperature - no heat gun needed.
Cutting line or dental-floss tool lets you work slowly and precisely behind any badge.
One IPA wipe after cleanup and the panel is flat, clean and ready for the next stage.
Kit vs Improvised Methods
Fishing line and household solvent can get the badge off, but the Soft99 kit gives you the right tool for each stage - controlled lifting, a safe formula, and a clean result without the guesswork.
| Feature | DetailerSA | Alternative |
|---|---|---|
| Clear-coat safe adhesive remover included | Yes | No |
| Dedicated cutting line for controlled badge lifting | Yes | No |
| Removes badge and adhesive residue | Yes | Yes |
| Works without a heat gun | Yes | Yes |
| Risk of solvent damage to clear coat | No | Yes |
| All required tools in one package | Yes | No |
Panel Prep Done Right
Whether you're prepping for a full ceramic coating, laying PPF or heading straight into paint correction, the kit leaves the surface flat and residue-free after one IPA wipe - no separate degreasing step, no adhesive ghost lines to deal with later.
Reviews
Debadged the boot lid on my sedan before laying down ceramic - this kit made it straightforward. Residue came off without any scrubbing, and the paint underneath was clean enough to coat after a single IPA wipe.
Does the job neatly. I warmed the badge first with a heat gun and the line cut through the tape in one slow pass. The adhesive remover sorted the leftover gunk with minimal effort - just give yourself time and don't rush the lifting step.
Questions
Thread or press the cutting line behind the badge and work it slowly through the adhesive layer with a gentle sawing motion. Once the emblem is free, apply the adhesive remover to any remaining tape residue and allow it to dwell briefly before wiping away. Finish with an IPA wipe to leave the panel clean and ready for your next step.
Yes. The formula is purpose-designed to dissolve factory adhesive tape without attacking the clear coat underneath. Work on a cool panel out of direct sun and avoid prolonged soaking on raw edges or fresh respray work.
The cutting tool is suitable for lifting emblems off wrapped or PPF-covered panels, but test the adhesive remover on a hidden edge first before applying it to any film, as solvent tolerance varies between wrap films and PPF brands.
Yes. The kit handles both pressed or moulded badges bonded with tape and flat adhesive stickers. Softer sticker material may need less force on the cutting line - let the remover do the work on the adhesive rather than forcing the line.
The kit is designed to work without a heat gun. The adhesive remover breaks down the factory tape at ambient temperature. That said, warming the panel slightly with a heat gun or hot water can make very thick factory tape easier to cut through, especially in colder conditions.
Allow the remover to dwell for 30-60 seconds on stubborn residue so it can penetrate and soften the tape. Wipe away with a clean microfibre cloth and repeat on any spots that need a second pass.
Follow up with an IPA (isopropyl alcohol) wipe to remove any remover residue and degrease the surface fully. The panel is then ready for paint correction, ceramic coating application, PPF installation or wrapping.
If the badge has been on the car for years, there may be a shadow or slight paint fade line where UV exposure differed. The Soft99 kit removes the badge and adhesive cleanly, but pre-existing paint fading or oxidation around the badge outline is a paint correction job, not a removal issue.
