Soft99 Double Faced Adhesive Tape: 20mm x 2.5m

It is designed for automotive use and bonds well to painted bodywork, hard plastic trim, metal mouldings and rubber-backed strips. Always test on a small area if you are unsure about the substrate.

Yes - a clean, dry and grease-free surface is essential for a strong bond. Wipe both surfaces with an IPA (isopropyl alcohol) solution before application. Any wax, polish residue or contamination will reduce adhesion significantly.

Allow at least 24 hours of dwell time at room temperature before the bond is exposed to pulling, flexing or washing. Colder conditions slow the adhesive cure, so give it longer in cooler environments.

We recommend caution on PPF and vinyl. Aggressive adhesives can lift the film edges when removed. Test in an inconspicuous area first and avoid using it near seams or edges of any film.

Freshly painted panels need adequate cure time before any adhesive tape is applied - typically at least 30 days for a full solvent paint cure. Applying earlier risks pulling or marking the finish when the tape is removed.

Warm the tape gently with a heat gun or hairdryer to soften the adhesive, then peel slowly at a low angle. Any remaining residue can be lifted with an IPA wipe or a dedicated adhesive remover - avoid anything abrasive.

This tape is intended for exterior body and trim repairs rather than under-bonnet applications. Extreme heat cycles in the engine bay can break down the adhesive over time. For high-heat areas, use a tape rated specifically for those temperatures.

The tape can conform to mild curves when cut into shorter sections and applied progressively. For tight contours, cut the tape into smaller pieces and press each section individually to maintain full contact along the bond line.