This transparent and high-strength surface coating from the servFaces line is a diverse and unique quality product for plastic surfaces. Plastic Coat provides optimum protection for untreated, natural-finish plastic surfaces and creates silky gloss effects.
The highly-transparent coating forms a long-acting protective film resistant to dirt and easy to clean with minimum consumption. Plastic Coat is resistant to temperatures up to +680°C as well. Therefore, surfaces' fireproof properties will not be negatively affected. The product cannot be removed with conventional cleaning agents. servFaces Plastic Coat has a special integrated UV blocker which effectively protects untreated plastics from discoloration for a long time.
servFaces Plastic Coat is very flexible up to a film thickness of 5 µm and therefore cannot chip or peel off.
Areas of application:
Untreated or natural-finish plastic surfaces
Properties:
Long-term protection
Very high hydrophobic properties
Resistant to washing bays stable gloss
Resistant to cleaning agents environmental influences (pH 2 - 13)
UV resistant environmentally stable
Easy-to-clean surfaces
Unique gloss color depth
Resistant to temperatures of -50°C - +680°C
Simple application
Use:
Clean the surface with Surface Cleaner Ultima followed by Surface Cleaner Neutra to neutralize It
Put the application cloth onto the applicator.
Apply 12 - 18 drops of Plastic Coat onto the application cloth and spread it quickly on the surface (a visible film should form). Treat the surface in small sections (max. 50 x 50 cm).
Let the product dry for approx. 1 - 3 minutes! (The time depends on the applied quantity, air humidity and ambient temperature). The longer the product reacts on the surface, the thicker the coating and the greater the protective and hydrophobic effects.
Remove surplus material with a Special Coating Towel (peripheral areas first, then work from the outside in with straight quick motions).
Take another fresh Special Coating Towel and polish the surface with slight pressure (peripheral areas first, then work from the outside in with circular motions).
Should streaks still be visible, take another fresh Special Coating Towel and repeat the procedure until the streaks are invisible. (Check with a light)
Recoating with Plastic Coat: possible after 20 minutes. Wait no longer than 35 minutes!
The product can be applied by fine spraying, too. You will need clean, dry and oil-free compressed air for that! Contaminants in the compressed air can cause a pre-reaction of the product after which the treated surfaces become dull and rough.
Caution: Do not apply the product in direct sunlight!
Lifetime:
One layer of Plastic Coat has a lifetime of approx. 24 - 36 months. Each additional layer enhances the lifetime for a further 8 - 9 months.
To achieve a longer protection time, you can apply the product in a fine spray pattern and leave to dry. In this way, you will obtain a dry film thickness of approx. 3 - 5 µm.
Application temperature: +15°C to +35°C
Consumption: 3 - 5 ml per m²
Weatherproof: after 18 - 24 h
Fully cured: after 9 - 10 days
pH resistance: pH 2 - 13
Storage temperature: +10°C to +25°C
Storage and shelf life: At least 12 months at ambient temperature in tightly sealed original container stored upright
Caution: Protect the product from direct sunlight and freezing temperatures!
Note:
Emulsions and coating products need a certain period of time to bind to the surface and fully cure after application. Therefore, please check the curing time of individual products. Only this can guarantee that the product provides the desired benefits. Direct exposure of the surface to water or cleaning agents after application can considerably reduce the product's properties.
General information about the product:
Factors such as preliminary cleaning, application temperature, curing time, etc., can influence the product's effectiveness and lifetime. Therefore, fluctuations of product properties cannot be excluded.
